Friday, November 20, 2026

2.92 Vertical Launch PCB Connector for Solderless 40 GHz Testing

If you've ever soldered a connector onto a thin RF board, you know how easily it goes wrong. Leave the iron on a second too long and the pad starts to lift. Use a little too much solder and you've built an impedance step into the launch, which turns up later as poor return loss somewhere around 35 GHz. A 2.92 vertical launch PCB connector avoids the problem by not using solder at all. Two screws hold it to the board, pressure keeps the center pin on the trace, and when the layout changes you just unscrew it and reuse it.

How a 2.92 Vertical Launch PCB Connector Mounts Without Solder
Mounted, the connector points straight up from the board. The flange is tiny, 10.2 mm by 5.7 mm in stainless steel, with a pair of 1.6 mm screw holes 7.15 mm apart. Snug the screws down and the connector clamps against the PCB, pressing the pin onto the pad and keeping it there. There’s no heat involved at any point, so the board you mount it on is the same board you got back from fab: no lifted copper, no scorched laminate. On anything thinner than 0.010", that’s a real advantage. Those boards rarely survive a botched rework.

Key Specs

  • Frequency: DC to 40 GHz

  • VSWR: 1.20 (1.25 on the spring-pin model)

  • Insertion loss: ≤0.05 x √f(GHz) dB, roughly 0.32 dB at 40 GHz

  • Operating range: -40°C to +125°C

Choosing a 2.92 Vertical Launch PCB Connector for Your Board 
The version you need depends on your transmission line:
  • 2.92-KFD216 ($19.90) for CPW and microstrip

  • 2.92-KFD216-1 ($19.90) for stripline

  • 2.92-KFD216-1P ($29.90) for stripline, with a spring-loaded center pin that keeps contact consistent

Decide on the version early, ideally before the footprint is locked in. Put a microstrip launch on a stripline board and the transition won’t be clean, and fixing that after fab costs a lot more than fixing it in layout. Need to go past 40 GHz? The same solderless PCB connector family also comes in 2.4mm, good to 50 GHz, and 1.85mm, good to 67 GHz.




2.92 Vertical Launch PCB Connector for Solderless 40 GHz Testing

If you've ever soldered a connector onto a thin RF board, you know how easily it goes wrong. Leave the iron on a second too long and the...